DAV with float control DN 100 PN 10/16

1406100000 DAV with float control DN 100 PN 10/16

1: Main valve
2: Ball valve (A, B)
3: Filter
4: Orifice
5: Throttle check valve
6: Control valve
7: Pressure gauge with ball valve
8: Optical position indicator (optional: Electrical position indicator, opening limiter)
9: Float control valve

Product attributes

The main valve is a hydraulically operating diaphragm valve. The work energy is the inherent medium.
Most valve types operate purely hydraulically without any foreign energy.

To use in drinking water systems (other media after consultation)
As an open/shut valve with hydraulic control for filling reservoirs, when the system must not fall below the level of the inlet pressure

The pressure–sustaining valve with float control opens when the water level is low taking into account the set holding pressure The closing procedure is slow in order to avoid shock pressure loads. Variable flow rate has no effect on the holding pressure which is regulated by the control valve. The overpressure or maintained pressure can be set within the range of 2 bar to 16 bar (standard design). The valve closes when the level of water in the reservoir has been reached.

To calculate the dimensions of the valve please refer to the following information:
Maximum and minimum inlet pressure (static and dynamic pressure ratios)
Desired maximum loss of pressure
Maximum and minimum flow rates
Available line diameters and lengths
Construction of the valve (straight or angle design)
For the calculation basis, information on the loss of pressure and the characteristic values of the valve, please refer to the end of Chapter E.

Design according to DIN EN 1074
Construction length acc. to DIN EN 558
Flange mass according to DIN 1092-2, to PN 25 DN 300
Pressure levels: PN 10 or PN 16 to DN 300, PN 25 to DN 200, higher pressures on request.
Nominal widths DN 50, DN 80, DN 100 and DN 150 available in angular design
Nominal widths 1 ½" and 2" with threaded connection (female thread)
Medium temperature up to 40°C

Shut–off valves should be fitted on both sides of the valve and a dirt trap should be installed on the inlet side of the valve. Depending on the installation situation, a mounting/dismounting adapter should be provided. If there is a free run into the reservoir (without any counterflow from the reservoir) the outlet slider can be omitted.