DAV for hydraulic third-party control DN 300 PN 10/16

1402300000 DAV for hydraulic third-party control DN 300 PN 10/16

1: Main valve
2: Ball valve (A, B)
3: Filter
4: Orifice
5: Throttle check valve
6: Control valve
7: Pressure gauge with ball valve
8: Optical position indicator (optional: Electrical position indicator, opening limiter)
LP - external pressure (lower than p1 resp. HP)
HP - Higher pressure

Product attributes

The main valve is a hydraulically operating diaphragm valve. The work energy is the inherent medium.
Most valve types operate purely hydraulically without any foreign energy.

To use in drinking water systems (other media after consultation)
Sustaining the network pressure in a supply in relation to a specific external pressure
As an open/shut valve with minimal holding pressure and hydraulic control.

The input pressure control valve opens when there is a specific predetermined difference in pressure between the inlet pressure (p1) and a lower external pressure. The closing procedure is slow in order to avoid shock pressure loads. Variable flow rates have no effect on the maintained pressure which is regulated by the control valve.

To calculate the dimensions of the valve please refer to the following information:
Maximum and minimum inlet pressure (static and dynamic pressure ratios)
Required sustained pressure or dischargepressure
Possible pressure differential of the external pressure
Maximum and minimum flow rates
Available line diameters and lengths
Construction of the valve (straight or angle design)
For the calculation basis, information on the loss of pressure and the characteristic values of the valve, please refer to the end of Chapter E.

Design according to DIN EN 1074
Construction length acc. to DIN EN 558
Flange mass according to DIN 1092-2, to PN 25 DN 300
Pressure levels: PN 10 or PN 16 to DN 300, PN 25 to DN 200, higher pressures on request.
Nominal widths DN 50, DN 80, DN 100 and DN 150 available in angular design
Nominal widths 1 ½" and 2" with threaded connection (female thread)
Medium temperature up to 40°C

Shut–off valves should be fitted on both sides of the valve and a dirt trap should be installed on the inlet side of the valve. If the valve outlet flows to the outside or into a shaft, the outlet slider can be omitted. Depending on the installation situation, a mounting/dismounting adapter should be provided.